subject
Engineering, 02.12.2019 19:20

Agundrilling operation is used to drill a 9/64-in diameter hole to a certain depth. it takes 4.5 minutes to perform the drilling operation using high pressure fluid delivery of coolant to the drill point. the current spindle speed = 4000 rev/min, and feed = 0.0017 in/rev. in order to improve the

surface finish in the hole, it has been decided to increase the speed by 20% and decrease the feed

by 25%. how long will it take to perform the operation at the new cutting conditions?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 12:20
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 03.07.2019 12:20
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 03.07.2019 12:30
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 03.07.2019 12:30
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
You know the right answer?
Agundrilling operation is used to drill a 9/64-in diameter hole to a certain depth. it takes 4.5 min...
Questions
Questions on the website: 6713912